Troubleshooting
Symptom Remedy
The display shows ‘BAD VERSION’ The system version of your DVD recorder is
already newer than that at the CD-ROM.You
cannot upgrade with this disc.
The display shows ‘SYS UNSUPP’. Upgrading is not supported for this configuration.
Contact your Philips Customer Care Center.
The display shows ‘ERROR’ or An error occurred during the upgrade
‘ENGINE ERROR’. procedure.Try once again. If the problem
persists, contact your Philips Customer Care
Center.
Some of the system settings Reset the DVD Recorder as follows: Disconnect
have changed, such as the date the recorder from the mains; reconnect it while
or language preferences. holding the STANDBY/ON button pressed
until the display lights up.You will need to redo
the installation procedure.
- 8 -
English
To Next Page
Loading...
