Philips DVDR985 - Page 27

73202 - Invalid input.
73203 - Communication with Analog Board fails
80000 - The DVIO module is present in the sys-
tem.
80001 - The DVIO module is not present in the
system.
80100 - The DVIO module has been reset OK.
80101 - The DVIO module is not present in the
system.
80102 - The DVIO module could not be reset.
80103 - Could not initialize I2C before Reset.
80200 - The accessibility of the DVIO module is
OK.
80201 - The DVIO Board is not present in this
DVDR.
80202 - Could not initialize I2C.
80203 - Unable to reset the DVIO module.
80204 - Unable to receive the reset indication
from the DVIO module.
80205 - Unable to send the configuration to the
DVIO module.
80206 - Unable to download the chip ID to the
DVIO module.
80207 - Unable to set the mode of the DVIO
module to IDLE.
80208 - Software Error in function Handle State
Awaiting Reply!!
80209 - Maximal number of retries reached by
Handle State Sending!!
80210 - Maximal number of retries (NACKs)
reached (Handle State Sending)
80211 - We tried to receive a reply for
DVIO_MAX_RETRIES_ACKREPLY times !!
80212 - We tried to receive a reply for
DVIO_MAX_RETRIES_REPLY times !!
80213 - We tried to receive an Ack for
DVIO_MAX_RETRIES_ACK times!!
80214 - VSM UART error timeout transmitting
command
80215 - VSM UART error timeout receiving reply
80216 - VSM UART frame error occurred receiv-
ing from DVIO Board
80217 - VSM UART parity error occurred receiv-
ing from DVIO Board
80218 - The confirmation/indication from the
DVIO module is invalid.
80300 - The accessibility of the DVIO module is
OK.
80301 - The DVIO Board is not present in this
DVDR.
80302 - Could not initialize I2C.
80303 - Unable to reset the DVIO module.
80304 - Unable to receive the reset indication
from the DVIO module.
80305 - Unable to send the configuration to the
DVIO module.
80306 - Unable to download the chip ID to the
DVIO module.
80307 - Unable to set the mode of the DVIO
module to IDLE.
80308 - Software Error in function Handle State
Awaiting Reply!!
26