80702 - The I2C could not be initialized.
80703 - The DVIO module could not be reset.
80704 - Unable to receive the reset indication
from the DVIO module.
80705 - Unable to send the configuration to the
DVIO module.
80706 - Unable to download the chip ID to the
DVIO module.
80707 - Unable to set the mode of the DVIO
module to IDLE.
80708 - Software Error in Handle State Awaiting
Reply function!
80709 - Maximal number of retries reached by
Handle State Sending!
80710 - Maximal number of retries (NACKs)
reached (Handle State Sending)
80711 - We tried to receive a reply for
DVIO_MAX_RETRIES_ACKREPLY times!
80712 - We tried to receive a reply for
DVIO_MAX_RETRIES_REPLY times!
80713 - We tried to receive an
Acknowledgement for
DVIO_MAX_RETRIES_ACK times!
80714 - VSM UART error timeout transmitting
command
80715 - VSM UART error timeout receiving reply
80716 - VSM UART frame error occurred receiv-
ing from DVIO Board
80717 - VSM UART parity error occurred receiv-
ing from DVIO Board
80718 - The confirmation/indication from the
DVIO module is invalid.
80719 - Setting the DVIO module in/out diagnos-
tics mode failed
90121 - Error: Audio data in host memory con-
tains wrong frequency: frequency Hz
90122 - Error: Audio data in host memory con-
tains silence!
90123 - There is no correct audio frame in the
buffer
90124 - The audio frame has an illegal version
bit
90125 - The audio frame has an illegal bitrate-
index
90126 - The audio frame has an illegal sampling
rate
90127 - The CRC of the audio frame is wrong
90128 - The audio frame is not MPEG-I layer II !
90129 - Error cannot de-mute DAC on Analog
Board
90201 - Initialization of I2C failed
90202 - Initialization of VIP and EMPIRE failed
90203 - Initialization of PLL / Link failed.
90204 - Next descriptor address set wrong.
90205 - Turning on the colorbar failed
90206 - No I2C communication possible to start
video encoder.
90207 - Starting the video encoder failed.
90208 - Transfer of data from video encoder to
VSM failed.
90209 - Stopping the encoder failed.
90210 - Turning off the colorbar failed.
90211 - Cannot initialize hostdecoder parallel
29
To Next Page
