27
Adjust settings
[ Digital Audio ]
Select the setting based on the digital
ampli er/receiver that is connected
through the digital jack.
[ Digital Output ]• – select the type of
digital output.
Option Description
[ Off ] Disable digital output.
[ All ] The device supports
multi-channel audio
formats.
[ PCM Only ] The device is not capable
of decoding multi-channel
audio. Audio is
downmixed to two-
channel sound: see
[
LPCM Output ]
setting.
[ LPCM Output ]• – select the LPCM
(Linear Pulse Code Modulation) output
sampling rate.
Option Description
[ 48kHz ] For discs recorded at
sampling rate of 48 kHz.
[ 96kHz ] For discs recorded at the
sampling rate of 96 kHz.
Note
[ LPCM Output ]• setting is only available if the
[ Digital Output ] is set to [ PCM only ].
The higher the sampling rate, the better the sound
•
quality.
[ Volume ]
Set the default volume level when you play
a disc.
Press 1. OK.
Press 2. b B to set the volume.
Press 3. OK to con rm and exit.
[ Sound Mode ]
Select a preset sound effect to enhance
the audio output.
[ 3D ]• – select a virtual surround sound
effect that is produced from the left and
right audio channels.
[ Movie Mode ]• – select a sound effect
for movies.
[ Music Mode ]• – select a sound effect
for music.
[ Speaker Setup ]
When you connect a speaker system, you
can optimize surround output for the
connected speakers.
[ Front Speaker ]•
Option Description
[ Large ] Produce low frequency
signal below 120 Hz.
[ Small ] Cannot produce low
frequency signal below
120 Hz.
Downloaded From Disc-Player.com Philips Manuals
To Next Page
Loading...
