Why is there no picture on my Philips DVD Player?
If there is no picture on your Philips DVD Player, check your TV manual for the correct video input channel selection and change the TV channel until you see the DVD screen. If this occurs after turning on progressive scan or changing the TV system setting, revert to default mode by opening the disc compartment and pressing the numeric button ‘1’ (for progressive scan) or ‘3’ (for TV System).
Audio Specifications| audio D/A converter | 24-bit, 192 kHz |
|---|---|
| frequency response | 30-20, 000 Hz |
| signal to noise ratio | > 100 dB |
| distortion and noise (1 kHz) | > 85 dB |
| crosstalk (1 kHz) | > 100 dB |
| dynamic range (1 kHz) | > 90 dB |
Video Specifications| video D/A converter | 12-bit, 108 MHz |
|---|---|
| picture enhancement | Progressive scan, Video upsampling |
Playback Media and Formats| video playback media | CD, CD-R/CD-RW, Video CD/SVCD, DVD, DivX, DVD+R/+RW, DVD-R/-RW, DVD-Video |
|---|---|
| audio playback media | CD, MP3-CD, MP3-DVD, WMA-CD, CD-R/RW, Audio CD |
| compression formats | MPEG1, MPEG2, DivX 3.11, DivX 4.x, DivX 5.x, DivX 6.0, MP3, Dolby Digital, PCM, WMA |
Power| power consumption | < 10 W |
|---|---|
| power supply | 50 Hz, 230 V |
| standby power consumption | < 1 W |
Weight and Dimensions| set dimensions (W x H x D) | 360 x 37 x 209 mm |
|---|---|
| packaging dimensions (W x H x D) | 480 x 80 x 282 mm |
| device weight | 1.3 kg |
| weight including packaging | 2.4 kg |
To Next Page
