The NBP Numeric Pane
6-4 EarlyVue VS30 Instructions for Use
A pulse rate derived from the NBP measurement is displayed in the Pulse numeric pane
if Pulse Source is set to NBP, or if Pulse Source is set to Auto and there is no SpO
2
measurement available. For details, see Chapter 10, “Monitoring Pulse Rate.”
Below the NBP numeric pane are buttons to manually start an NBP and, in Interval or
Continuous monitoring mode, to set NBP intervals. These buttons, and their associated
monitoring modes are described in the following table. The buttons change depending
on the monitoring mode and whether QuickNBP has been enabled by your system
administrator. For additional information, see “NBP Measurement Methods” on page 6-9
and “Manually Starting an NBP Measurement” on page 6-10.
Button Notes
All Monitoring Modes
Standard Start NBP and Stop NBP buttons.
When you start an NBP, either from the main screen or
from the NBP menu, the Start NBP button changes to
Stop NBP.
If your system administrator has enabled QuickNBP, the
buttons on the main screen default to QuickNBP buttons.
If Quick NBP is not enabled, but you start a QuickNBP
from the NBP menu, the Stop button changes to Stop
QuickNBP.
If you start a STAT NBP from the NBP menu, the Stop
button on the main screen changes to Stop STAT.
Interval Monitoring Mode and Continuous Monitoring Mode
Opens the Interval Settings or Continuous Settings
menu.
Start NBP
Stop NBP
Start QuickNBP
Stop QuickNBP
Stop STAT
Set Interval
To Next Page
Loading...