Philips EarlyVue VS30 - Managing Printed Waveforms

Managing Printed Waveforms
13-6 EarlyVue VS30 Instructions for Use
Managing Printed Waveforms
In the Recorder Settings menu, you can adjust how waveforms appear when printed,
To adjust waveform settings
1 On the main screen, touch the Settings button.
2 On the System menu that opens, touch the Recorder Settings button.
3 Make selections from the following menus:
- Recorder Speed
- Waveform Print
- Number of Real-Time Waves
- Real-Time Wave
4 Touch the Close button at upper right to return to the main screen, or touch the
Back button to return to the General tab of the System menu.
The effects of the settings are described below.
Recorder Speed
The Recorder Speed setting defines the printing resolution of all waveforms.
By default the recorder speed is 25 mm/sec, which means one second of waveform data
is printed on 25 mm of paper. Selecting a lower speed increases the resolution of the
printed waveform, and vice versa.
You can select 6.25, 12.5, 25, or 50 mm/sec.
Waveform Print
The Waveform Print setting specifies the length, in seconds, of the printed waveform. It
also determines which measurement values are used to generate printed waveforms.
You can select either 7 or 20 seconds, with the following effects:
• If you select 7 seconds, the printed waveform includes the values that occur for the
first 7 seconds after you touch the Print icon.
• If you select 20 seconds, the printed waveform includes the values that occur 7
seconds before and 13 seconds after you touch the Print icon.