Philips epiq 5 - Media Export Settings

EPIQ 5 & 7 Training Manual
© 2016 Conquest Imaging
36
Network Setup Procedures
The following are standard networking set up procedures. Help topics
are available on the system screen.
Set Type of Connection Ethernet or Wireless
You can set the connection type manually or use the Setup Wizard to
set up all the connectivity settings. It is best to use the wizard unless
you are only changing a parameter or very knowledgeable with
regard to DICOM settings.
From the touch screen you can use the Setup Wizard to set the type
of network connection:
 Touch Utilities.
 On the System tab, touch Setups.
 Click Setup Wizard  Getting Started and click Next three
times.
 In Export and Storing Data, click Store to PACS (DICOM Data,
Image/CineLoops).
 Click Yes, I want to setup network connectivity  Network
Connectivity.
 In Your Network Settings, click Edit.
 Continue through the setup wizard until you have set all network
connectivity settings. The setup wizard will automatically save
changes.
Manually Set Network Connection Type
To select the network connection type for the system:
 Press Support and click on the Network/DICOM tab.
 Click Network Settings.
 In Network Information, click Wired or Wireless. (If you want to
temporarily disable the Network Information setting, click