Philips epiq 5 - Page 45

EPIQ 5 & 7 Training Manual
© 2016 Conquest Imaging
37
Disable.)
Configure Ultrasound System for a Network Connection
To change the dynamic (DHCP) or static IP connection status:
 Press Support and click the Network/DICOM tab.
 Click Network Settings  TCP/IP Properties.
 Do one of the following:
 To use a dynamic IP address, click Obtain an IP Address
Automatically.
 To use a static IP address, click Use the Following IPv4
Address and type the IP address.
 Click OK and then click Navigator  DICOM Settings.
 Under Ultrasound DICOM Settings, enter the following
information:
 AE Title
 Port Number (a change in this field will cause the system
to restart)
 Station Name
 Station Location
Configure DNS Settings
To configure the DNS settings for your system:
 Press Support.
 Click the Network/DICOM tab.
 Click DNS Settings.
 If the network administrator specifies domain name server
(DNS) IP addresses, click Use the Following DNS Server IP
Addresses (in order) and add one or more DNS addresses.
 If the network administrator specifies DNS suffixes, click
The values entered for
Station Name and Station
Location must match the
corresponding Modality
Worklist field values.
Those fields can be left
blank, if the station name
or system location are not
being used in the worklist,
or if a worklist server is
not configured. The
network administrator
should be able to provide
this information.
Note:
If the system does not use
DHCP to specify the
addresses of domain
name servers, you must
enter the DNS settings for
the system before you
connect the system to
either a wired or a
wireless network.