EPIQ 5 & 7 Training Manual
© 2016 Conquest Imaging
b. Verify that the displayed image is spatially correct,
horizontally and vertically.
To Test Printer Operation:
1. Start an exam:
a. Touch Patient.
b. Click End Exam to ensure the previous exam was
ended.
c. Enter the patient data.
d. Click Done.
e. Select a transducer from the touch screen.
f. Touch an application/preset.
2. Acquire a 2D image.
3. Press Freeze.
4. Determine which print controls are associated with the
printer.
a. Touch Utilities.
b. On the System tab, touch Setups.
c. Click Acquisition/Capture.
d. Click the Archive/Printer tab.
e. Note which controls are associated with which
printers.
5. Press Acquire 1, Acquire 2, or the touch screen controls
associated with the printer.
6. Verify that the print contains the region of interest and full-
screen images.
7. Verify that the graphics and gray bar on the print are in sharp
To Next Page
Loading...