EPIQ 5 & 7 Training Manual
© 2016 Conquest Imaging
Module 7 Parts Replacement
Parts replacements can be made to the system. Check the model
number and other vital information before ordering parts for the
system.
Safe Parts Replacement
You should follow the safety procedures and warnings documented in
the system user manual when replacing parts or modules.
Power Down
Before performing maintenance on the system be sure to follow
proper power down procedures and be mindful of proper ESD
procedures during any maintenance. Some important points to
remember when you power down to perform maintenance or
repairs:
Make sure system is NOT in sleep mode before powering down.
Disconnect AC power from wall socket. Philips recommends
disconnecting power cord from system power supply receptacle
and hanging it from the hanger at the rear of the system.
Remove system batteries if present.
Wait at least 30 seconds before removal or installation of any
component, module or PCB.
To Next Page
Loading...