20
English
3139 116 19341
RECORDING CLOCK
Notes:
– At the end of side A, flip the tapes to
side B and repeat the procedure.
– Dubbing of tapes is only possible from
tape deck 1 to tape deck 2.
– To ensure good dubbing, use tapes of
the same length.
– You can switch to other source while
dubbing.
Recording from other sources
(only on tape deck 2)
1 Press TAPE ( TAPE 1•2 ) to select tape
deck 2.
2 Load a blank tape into tape deck 2 with
the open side downward.
3 Press CD, TUNER or AUX.
• Start playback of the selected source.
4 Press REC to start recording.
™ The REC starts flashing.
5 Press Ç to stop recording.
Notes:
– During recording, it is not possible to
listen to another source.
View Clock
You can view the clock (if it is set) if the
system is in Standby mode or when any
sound source is selected (CD, TUNER, etc.).
The clock will be displayed for about seven
seconds.
• Press CLOCK•TIMER briefly.
™ “10:38 PM or 22:38” (the current
time) will be displayed depending on
whether you have selected 12- or 24-
hour mode.
™ “--:--” will be displayed if the
clock is not set.
Clock Setting
The clock can be set in either 12- or 24-
hour mode, e.g. “12:00 AM“ or
“00:00“. Before setting the clock, you
must be in the View Clock mode.
1 Press CLOCK•TIMER to select clock
mode.
2 Press PROGRAM to select 12- and 24-
hour mode.
™ If 12-hour mode is selected,
“12:00“ starts flashing and the AM
lights up.
™ If 24-hour mode is selected,
“00:00” starts flashing.
3 Set the hour with à or á on the
system.
4 Set the minute with í or ë on the
system.
To Next Page
Loading...
