EasyManua.ls Logo

Philips FW-C505 - To rewind or fast forward when playback is stopped; To reset tape counter number; General Information on Recording; Preparation for Recording

Philips FW-C505
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
23
English
3139 115 21531
To rewind or fast forward when playback
is stopped
1 Press à or á.
2 Press Ç when you reached the desired passage.
To reset tape counter number
When in stop mode, pressÇ.
T1 000 or T2 000 will be displayed.
Notes:
During rewinding or fast forwarding of a tape, it
is also possible to select another source (CD,
TUNER or AUX, for example).
The tape counter will automatically set to zero
after detecting end of tape.
General Information on
Recording
For recording, use only tape of IEC type I
(normal tape).
The recording level is set automatically, regardless
of the position of the Volume, VAC, DSC and so
forth.
The tape is secured at both ends with leader
tape. At the beginning and end of the tape,
nothing will be recorded for six to seven
seconds.
To prevent accidental recording, break out the
tab on the left shoulder of the tape side you
want to protect.
If CHECK TAPE is displayed, the protection
tab has been broken. Put a piece of clear
adhesive tape over the opening.
IMPORTANT!
Recording is permissible if copyright or
other rights of third parties are not
infringed upon.
Recording is possible only on tape deck 2.
Preparation for Recording
1 Press TAPE (TAPE 1•2) to select TAPE 2.
2 Load a recordable tape into tape deck 2 with full
spool to the left.
3 Prepare the source to be recorded.
CD – load the disc(s).
TUNER – tune to the desired radio station.
TAPE – load the prerecorded tape into tape
deck 1 with the full spool to the left.
AUX – connect external equipment.
When recording is in progress
starts flashing.
It is not possible to listen to another source
except for dubbing tapes.
It is not possible to activate the timer function.
One Touch Recording
1 Press CD, TUNER or AUX to select the
source.
2 Start playback of the selected source.
3 Press REC to star t recording.
To stop recording
Press Ç on the system.
Note:
One Touch Recording is not possible in TAPE
mode, "SELECT SOURCE" will be displayed.
Tape Operation/Recording
pg 001-030/C505/22-Eng 12/27/01, 11:11 AM23

Related product manuals