Philips FW-C55 - Sleep Timer; Maintenance

24
English
3139 116 19541
TIMER SLEEP TIMER MAINTENANCE
– If the source selected is CD, playback
will begin with the first track of the
selected disc or program. If the CD trays
are empty, TUNER will be selected
instead.
– If the source selected is TAPE, and if the
preset time is reached during high
speed dubbing, the TUNER will be
selected instead.
– The timer will not activate if a recording
is in progress.
To switch off the TIMER
1 Press and hold CLOCK/TIMER for more
than 2 seconds .
2 Press Ç on the system to cancel the
timer.
™ The timer is now switched off.
™ The display will show "OFF" and the
TIMER disappears.
To start the TIMER again (for the same
preset time and source)
1 Press and hold CLOCK/TIMER for more
than 2 seconds .
2 Press CLOCK/TIMER again to store the
start time.
™ The timer is now on.
™ The TIMER appears on the display.
Sleep Timer (only on remote control)
This feature allows you to select a length
of time after which the system will switch
to the standby mode automatically.
1 Press SLEEP TIMER on the remote
control repeatedly to select a period of
time.
™ The selections are as follows (time in
minutes):
60 ™ 45 ™ 30 ™ 15 ™ OFF ™
60 …
™ "SLEEP XX" or "OFF" will be
displayed. "XX" is the time in
minutes.
2 When you reach the desired length of
time, stop pressing the SLEEP TIMER
button.
™ After this amount of time passes, the
system will switch to the standby
mode.
To switch off the Sleep Timer
• Press SLEEP TIMER repeatedly until
"OFF" is displayed, or press the
STANDBY ON button.
Maintenance
Cleaning the Cabinet
• Use a soft cloth slightly moistened with
a mild detergent solution. Do not use a
solution containing alcohol, spirits,
ammonia or abrasives.
Cleaning Discs
• When a disc becomes
dirty, clean it with a
cleaning cloth. Wipe
the disc from the
center out.
• Do not use solvents
such as benzine,
thinner, commercially available cleaners,
or antistatic spray intended for analog
records.
Cleaning the CD lens
• After prolonged use, dirt or dust may
accumulate at the CD lens. To ensure
good playback quality, clean the CD lens
with Philips CD Lens Cleaner or any
commercially available cleaner. Follow
the instructions supplied with cleaner.
Cleaning the Heads and the Tape Paths
• To ensure good recording and playback
quality, clean the heads, the capstan(s),
and pressure roller(s) after every 50
hours of tape operation.
• Use a cotton swab slightly moistened
with cleaning fluid or alcohol.
• You can also clean the heads by playing
a cleaning tape once.
Demagnetizing the heads
• Use a demagnetizing tape available at
your dealer.
pg 01-26/C55-C58/34-En 2/22/00, 7:02 PM24