Philips FW-V320/21M - Technical Specifications; General Specifications; Tuner Specifications; Amplifier Specifications

1-2
General:
Mains voltage : 120 / 240V switchable (for /21)
: 230V (for /22)
: 120V (for /37)
Mains frequency : 50 ~ 60Hz
Power consumption : 85W at 1/8 P
RATED
: 350W at max output
: ≤15W at Stand by
: ≤2W at ECO Stand by
Tuner:
FM
Tuning range : 87.5MHz - 108MHz
Grid : 100kHz
IF : 10.7MHz
Aerial input : 75Ω
Sensitivity Mono (26dB S/N) : < 22dBf (typ. 16dBf)
d (RF=1mV,∆f=75kHz) : < 3% ( typ. 1%)
IF rejection : > 60dB
Image rejection : > 25dB
-3dB Limiting Point : < 23.5dBf (typ. 15dBf)
MW
Tuning range : 531kHz - 1062kHz
Grid : 9kHz
IF : 450kHz ±1kHz
Sensitivity at 26dB S/N : < 4400µV/m
d (RF=50mV,m=80%) : < 5% - typ. 3%
IF rejection : > 45dB
Image rejection : > 28dB
Amplifier:
Output power : 2 x 55W at 6Ω
Headphone : 3.5mm stereo jack
Frequency response : 20Hz - 20kHz (-3dB) Limit
Equalizer : Digital Sound Control
Input sensitivity
Aux/Line : 500mV ±2dB
Microphone : 2.5mV ±2dB at 1kHz
CDC unit:
Frequency response within : 20Hz - 20kHz at ±1.5dB
Signal/Noise ratio : > 88dB (A-weighted)
Distortion at 1kHz,0dB : -80dB
Channel unbalance : < 0.3dB
Channel crosstalk at 1kHz : -75dB
De-emphasis : 0 or 15/50 µS
Laser
Output power : ≤500µW
Wave length : 780nm ±20nm
CDR unit:
CD Playback:
Frequency response within : 20Hz - 20kHz at ±1.5dB
Signal/Noise ratio : > 88dB (A-weighted)
Distortion at 1kHz,0dB : -80dB
Channel unbalance : < 1dB
Channel crosstalk at 1kHz : -75dB
De-emphasis : 0 or 15/50 µS
Analog recording - digital playback:
Frequency response within : 20Hz - 20kHz at ±1.5dB
Signal/Noise ratio : > 81dB (A-weighted)
Distortion at 1kHz,0dB : -78dB
Channel unbalance : < 1dB
Channel crosstalk at 1kHz : -65dB
De-emphasis : 0 or 15/50 µS
Laser
Output power : ≤1mW during reading
: ≤20mW during writing
Laser class 3B
Wave length : 780nm ±20nm
Technical Specification