Preparations
SPEAKERS 6R
R
+
—
L
—
+
SUBWOOFER
OUT
AM
ANTENNA
FM
ANTENNA
LR
speaker
(right)
speaker
(left)
FM wire antenna
AM loop
antenna
B
C
AUX/CDR
A
AC power cord
VOLTAGE
SELECTOR
110V-
127V
220V-
240V
VIDEO
OUT
VIDEO
IN
Television
L
R
AUDIO
OUT
D
E
Rear connections
The type plate is located at the rear of the
system.
A
Power
Before connecting the
AC power cord to the
wall outlet, ensure that the following are done;
– If your system is equipped with a
Voltage Selector
, set the VOLTAGE
SELECTOR to the local power line
vo
ltage.
– All other connections have been made.
WARNING!
– For optimal performance, use only the
original power cable.
– Never make or change an y connections
with the power switched on.
B
Antennas Connection
Connect the supplied AM loop antenna and FM
antenna to the respective ter minals. Adjust the
position of the antenna for optimal reception.
AM
Antenna
P
osition the antenna as
far as possib le from a
TV, VCR or other
radiation source.
FM Antenna
For better FM stereo
reception, connect an
outdoor FM antenna to
the FM ANTENNA
terminal.
VO LTA
GE
SELECTOR
110V-
127V
220V-
240V
English
Preparations
C
Speakers Connection
Fr
ont Speakers
Connect the speaker wires to the SPEAKERS
terminals, right speaker to "
R" and left speaker to
"L
", coloured (marked) wire to "+" and black
(unmarked) wire to "-".
1
2
Fully inser t the stripped por tion of the speaker
wire into the terminal as shown.
Notes:
– For optimal sound performance, use the
supplied speakers .
– Do not connect more than one speaker to any
one pair of
+
/
-
speaker terminals.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
D
Video Out Connection
Connect the VIDEO OUT terminal at the rear
of the system to the TV or VCR VIDEO IN for
viewing or recording.
Note:
– To avoid magnetic interference with the picture
on your TV, do not position the front speakers too
close to the TV.
E
Connecting other equipment to your
system
Use a cinch cable to connect AUX/CDR IN to
the analogue audio out terminals of an external
equipment (TV, VCR, Laser Disc player, DVD
player or CD Recorder).
Note:
– If you are connecting equipment with a mono
output (a single audio out terminal), connect it to
the AUX/CDR IN left terminal. Alternatively, you
can use a “single to double” cinch cable (the output
sound still remain mono).
Inserting batteries into the
remote control
Inser t two batter ies type R06 or AA into the
remote control with the cor
rect polar ity as
indicated by the "+" and "-
" symbols inside
the battery compar tment.
CAUTION!
– Remove batteries if they are exhausted
or will not be used for a long time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances , so
they should be disposed off properly.
To Next Page
Loading...
