Service Position B
DISMANTLING INSTRUCTIONS (POWER BOOSTER AMPLIFIER BOX)
Dismantling the Rear Assembly
3
3
Service Position C
1. Remove 4 screws C at the bottom of the Power Booster
Amplifier Box as shown in Picture 4.
2. Remove 15 screws D (see Picture 5) to remove the Metal
Panel (pos 1).
3. Slide out the Main PCB assembly as shown in Service
Position B.
Picture 5Picture 4
Note: After repair, be very sure that the cables are tied and
restored properly to its original position.
To Next Page
Loading...
