Philips FW910SR/P22 - Tuning to Preset Radio Stations

23
English
Notes:
– When 40 radio stations are stored and
you attempt to store another radio
station, the display will show "
PROGRAM FULL ”. If you want to
change an existing preset number;
repeat steps 4 and 5.
– You can cancel manual programming by
pressing STOP•CLEAR
Ç on the
system only.
– During programming, if no button is
pressed within 20 seconds, the system
will exit program mode automatically.
Tuning to Preset Radio
Stations
• Press PRESET 4 or 3 to select the
desired preset number.
™ The preset number, frequency and
waveband appear on the display
Notes:
– You can cancel the automatic
programming by pressing PROGRAM or
STOP•CLEAR
Ç on the system only.
– If you want to reserve a section of
preset numbers, for example preset
numbers 1 to 9, select preset 10 before
starting automatic programming: now
only the preset numbers 10 to 40 will be
programmed.
Manual programming
1 Press TUNER.
2 Press TUNER (BAND) to select the
desired waveband : FM, MW or LW.
3 Press PROGRAM for less than one
second.
™ PROGRAM flag, the frequency and
preset number start flashing.
™ The next available preset number will
be displayed for selection.
4 Press TUNING à or á to tune to the
desired frequency.
• If you wish to store the radio station to
another preset number, press PRESET
4 or 3 to select the desired preset
number.
5 Press PROGRAM again.
™ PROGRAM flag will stop flashing,
and the radio station will be stored.
• Repeat the above procedure to store
other preset radio stations.
TUNER
Receiving RDS radio station Ç
RDS (Radio Data System) is a broadcasting
service that allows FM stations to send
additional information along with the
regular FM radio signal. This additional
information can contain:
• STATION NAME: The station name is
displayed.
• FREQUENCY: The frequency of the
station is displayed.
• PROGRAM TYPE: The following
program types exist and can be received
by your tuner: News, Affairs, Info, Sport,
Educate, Drama, Culture, Science,
Varied, Pop M, Rock M, M.O.R. (middle
of the road music), Light M, Classics,
Other M, No type.
• RADIO TEXT (RT): text messages
appear in the display.
When you have tuned to a RDS station, the
RDS logo (Ç) and the station name will
appear on the display:
• The display normally shows the radio
station name if available. By repeatedly
pressing RDS button you can change
the type of display information:
™ The display shows in turn:
STATION NAME ™ FREQUENCY ™
PROGRAM TYPE ™ RADIO TEXT
™ STATION NAME ...
Note:
– When you press the RDS button and the
display shows "
NO RDS ", it indicates
that either the tuned station is not
transmitting RDS signal or it is a non RDS
station.
RDS Time
Some RDS station may be transmitting a
real time clock at an interval of every
minute.
Setting the time with RDS clock
1 Press CLOCK/TIMER.
™ "--:--" or current time appears on
the display.
2 Press CLOCK/TIMER once more to
enter clock setting mode.
™ "00:00" or current time starts
flashing.
3 Press RDS.
™ The message "SEARCH RDS
TIME" will be displayed.
™ If the station does not transmit RDS
clock, "NO RDS TIME" will be
displayed.
™ When the RDS clock is read, "RDS
TIME" will be displayed. The
current clock time is displayed for 2
seconds and will be stored
automatically.
™ If within 90 seconds, the RDS time is
not detected, "NO RDS TIME" will
be displayed.