Philips FWD876/98 - Tuner Operations; Manual Preset Programming; Changing Tuning Grid

33
English
Changing tuning grid
In some countries (only applicable for certain
regions), this function can changes the
frequency steps between grid 9 and grid10,
the frequency step between adjacent channels in
the MW band is 9 kHz tuner mode, (10 kHz in
some areas). The preset frequency step in the
factory is 9 kHz.
1 Plug the AC power cord.
2 Press TUNER to select MW mode.
3 Press and hold 38 button for more than 5
seconds on the panel.
Note:
– All preset stations will be lost and need to be
reprogrammed.
Tuner Operations
Manual preset programming
1 Press TUNER key repeatedly to select the
desired tuner band: FM or MW.
2 Press and hold 1 / ¡ on the system or on
the remote control to search a radio frequency.
3 Press PROGRAM.
➜ “ PROG“ and “00 00.00” will display.
4 Press O / P or numeric keys (0-9) to
select the desired preset number.
5 After selecting an address number, press
PROGRAM again to store the radio station.
● Repeat steps 3-5 to store other preset radio
stations.
Note:
– If you attempt to store more than 40 preset
radio stations, “FULL” will be displayed.
- This until exits presetting mode if no button is
pressed with 20 seconds.
Selecting a preset radio station
● In tuner mode, press O / P or use the
numeric keys (0-9) to select the desired
preset number.
➜ The preset number and radio frequency
appear on the display panel.
Deleting a preset radio station
1 In tuner mode,press O or P keys to select the
preset radio station to be erased.
2 Press and hold 7 on the system until
“DELETED” appears on the display panel.
➜ The current preset radio station will be
deleted.
➜ The rest of the preset radio stations will shift
up.
● Repeat steps 1-2 to erase other preset radio
stations.
pg047-pg055_FWD876-Eng-98 2007.12.28, 9:4233