3-3 3-3
Dismantling the Rear assembly
1) Loosen 8 screws" A" as shown in the Picture 1(Rear
View) to pull out the Printed Circuit Board assembly.
Caution: Do not break the bundle of wires to the front.
Picture 3
A
Dismantling OF The Main Board
2) Loosen 4 screws "C" on the top of main board as show
in the Picture 3.
B
C
Picture 2
Picture 1
Dismantling OF The Power Board
1) Loosen 10 screw " B" at the back panel as shown in
the Picture 2 .
1) Loosen 4 screws" D "on the top of power board as
shown in the Picture 4.
D
Picture 4
SERVICE POSITION
DISASSEMBLY INSTRUCTIONS ( SUBWOOFER )
To Next Page
Loading...
