1) System Reset
a) Press "SYSTEM" button on R/C. TV show "SETUP"
b) Select the menu using the "
" and " " button on R/C
c) Go feature setup page to do system reset
2-1
2-1
Use up/ down to select region from 0 to 6
CHANGE REGON PAGE
Current Region : 2
CONFRIM
Press "OK" to confirm
3) Version Control Change
a) In open model , press "1" "5" "9" on the R/C
b) Press "OK" button on R/C to confirm
c) TV will show the message as below :
Version Setup Menu
Current Model: FWD876/98
DVD-Ver : 06-08-28-2 MCU-VER : 1.14
Ess Software : 5.1 .51.1
Servo:68230
If current model does not match your set,
use down-arrow key on remote to change.
Press "OK" to confrim
CAUTION !
This information is confidencial and may not be
distributed. Only a qualified service person should
reprogram the Region Code.
4) Password Change
a) Press "SYSTEM" on R/C button
b) Select the menu using the " " and " " button on R/C
c) Go feature setup page select "PASSWORD". TV show
"ENTER CODE".Press 4 times of "STOP" button on R/C.
d) Select "PARENTAL" "8 ADULT" on TV.
e) Enter PASSWORD to "1234".
"1234" is a default password supplied.
5) Checking on the Software version
a) Open the CD door.
b) Press "159" and "OK" on the remote control.
c) TV will show the version on screen
a) Press "STOP" button on R/C in open model
b) Press "7" "3" "4" "4" "6" "6" , the below message will be
shown on TV screen:
2) Region Code Change
6) Upgrading new software
a) Open the door, then insert the CD-R program disc.
b) Close the door.
c) TV will show:-
.
"disc loading"
.
"bank30.rom"
.
"writing" about 6 seconds.
.
"Done"
The latest upgraded is in version VER : 06-08-28-2
System ,Region code,etc.setting procdure
To Next Page
Loading...
