Downloaded from www.vandenborre.be
1 Switch off the appliance.
2 Remove the mains plug from the wall socket.
3 Put the iron on the iron platform and let the appliance cool down before you start to clean
it.
Never direct the steam at people.
1 To steam iron hanging curtains and clothes (jackets, suits, coats), hold the iron in vertical
position (Fig. 11).
2 Press the steam activator.
Never direct the steam at people.
During steam ironing, you can use the steam boost function to remove stubborn creases.
1 Set the temperature dial to a position between 3 and MAX.
2 Press the steam boost button (Fig. 12).
Note: Some water droplets may appear when you use the steam boost function for the rst time. The
water droplets disappear after you have used the steam boost function for some time.
- When the water in the water tank runs low during use, the ‘water tank empty’ light goes
on (Fig. 13).
1 Rell the water tank (see chapter ‘Preparing for use’).
Never immerse the iron and the steam tank in water or any other liquid, nor rinse them under
the tap.
Let the iron and the steam tank cool down sufciently before you clean them.
1 Clean the iron and the steam tank with a damp cloth.
2 Wipe scale and any other deposits off the soleplate with a damp cloth and a non-abrasive
(liquid) cleaner.
Let the appliance cool down sufciently before you remove the Calc-Clean rinsing cap.
Rinse the steam tank once a month or after you have relled the water tank 10 times.
1 Empty the water tank by pouring the water into the sink (Fig. 14).
2 Turn the cord storage hook anticlockwise (1) and remove it (2) (Fig. 15).
3 Turn the Calc-Clean rinsing cap anticlockwise (1) and remove it (2) (Fig. 16).
4 Shake the steam tank well over the sink.
9
4239.000.7496.1.indd 9 23-10-09 10:01
To Next Page
Loading...
Need help?
General