Problem Solution
The display shows
the wrong volume
(HD3720).
For proper functioning of the volume indication, it is crucial
that you open the tap handle completely (see chapter ‘How
to pour a perfect beer’).
In case of a power failure or if the appliance has been
disconnected from the mains, the level indication will be
accurate again after you have poured a few glasses of beer.
Pouring beer
No beer comes out
when I pull the tap
handle.
Perhaps the keg is empty. Put a new keg into the appliance.
Make sure the tube is tted correctly in the tap unit (see
chapter ‘Preparing for use’, section ‘Placing the tube into the
tap unit’).
Make sure that the tap unit is placed correctly on the keg (see
chapter ‘Preparing for use’, section ‘Placing the tap unit onto
the keg’).
Too much foam comes
out of the appliance.
Make sure you open the tap completely when you pour beer
(see chapter ‘How to pour a perfect beer’).
The beer is too warm. Wait until the beer is cold enough to
be poured, i.e. when temperature on the display is green
(HD3720 only) or when the green indicator light goes on
(HD3610).
The keg has been shaken too much. Wait half an hour for the
beer to settle.
The rst glass can contain more foam than usual. Try pouring
a second glass.
The tube may not function properly. Contact the PerfectDraft
call centre in your country to obtain a new tube.
The foam head is too
high.
See chapter ‘How to pour a perfect beer’.
The beer that comes
out of the appliance is
at.
Check if the keg has been open for over 30 days and check if
the expiry date of the keg has passed.
Perhaps the glasses you used were not clean enough. Rinse
the glasses with water and some washing-up liquid. Rinse
them thoroughly with cold water to remove all grease and
soap residues
Pour beer as described on the keg and in this user manual
(see chapter ‘How to pour a perfect beer’).
ENGLISH 25
To Next Page
Loading...
