7 To put the brewing unit back into the appliance, slide it onto the
supports and the pin at the bottom.
8 Press on the ‘PUSH’ area until the brewing unit snaps into place.
Note: After you hear the clicks, make sure the red buttons have snapped
outwards. Otherwise the service door cannot be closed.
Note: If you cannot insert the brewing unit, press the unit rmly from above
and below at the same time and then try to insert it. If you still cannot insert
the brewing unit, close the service door, unplug the appliance and then plug
it in again. Wait for all the lights to go off after the self-check, then open the
service door and reinsert brewing unit.
9 Reinsert the waste bin and the drip tray and close the service door.
Descaling
Regular descaling prolongs the life of the appliance and guarantees an
optimal coffee avour.
Run the descaling program when the message ‘PLEASE DESCALE!’ appears
on the display (see section ‘Descaling’ in chapter ‘Setting menu parameters’).
Replacement
You can order various removable parts from your Philips dealer or a Philips
service centre.
ENGLISH 27
4222.002.6507.7.indd 27 31-08-09 17:46
To Next Page
Loading...
