29
English
14 Empty the jug and remove the paper filter with the scale residues.
15 Fill the water reservoir with fresh cold water and press start button to start
another brewing process.
Let the coffee machine complete the entire brewing process and empty the
jug.
Note: If necessary, repeat step 14 until the water that comes out of the coffee
machine no longer tastes or smells of vinegar.
16 Clean the filter basket and the jug with hot water and some washing-up
liquid.
17 Press the power button to switch off the appliance.
Troubleshooting
This chapter summarizes the most common problems you could encounter with
the machine. If you are unable to solve the problem with the information below,
visit www.philips.com/support for a list of frequently asked questions or contact
the Consumer Care Center in your country.
You can also scan this QR code for more online support.
Problem Solution
The coffee machine does
not work.
Put the mains plug in the wall socket and press the on/off button to switch
on the coffee machine.
Make sure that the voltage indicated on the coffee machine corresponds to
the local mains voltage.
Fill the water reservoir with water.
Close the lid of the grinder funnel.
The grinder does not work
or does not work properly.
Make sure that you did not select pre-ground coffee. If the symbol for pre-
ground coffee is visible on the display, you selected pre-ground coffee.
Clean the grinder funnel by following the instructions.
When I use the grinder, the
coffee is too weak.
Turn the coarseness knob to select the desired type of grind from fine to
coarse.
Use the strength select button to set the coffee strength from 1 to 3，the
larger digit means stronger strength.
Use coffee beans of a stronger blend or flavor.
When I use pre-ground
coffee, the coffee is too
weak.
Make sure the amount of pre-ground coffee in the filter is enough, properly
increase the amount of pre-ground coffee will increase the coffee strength.
To Next Page
Loading...
