Philips HD8650 - Preparation for Descaling; Descaling cycle

Preparation
1 Switch off the machine.
If you do not switch off the machine, you cannot enter the descaling
cycle.
2 Empty the drip tray and place it back.
3 Empty the water tank and remove the Intenza+ water lter
(if present). Pour the entire bottle of descaling solution into
the water tank.
4 Add water to the descaling solution in the water tank up to
the MAX indication.
5 Place a bowl under the coffee spout.
Descaling cycle
1 Press the coffee button for approximately 5 seconds.
, The orange descaling light ashes slowly during the entire descaling
cycle.
, After each interval of one minute, the descaling solution ows out
of the coffee spout. This happens several times until the water tank
is completely empty.
Note: If you want to interrupt the ow of the descaling solution press the
coffee button.To restart the ow of the descaling solution, press the coffee
button again.
2 The ‘water tank empty’ light lights up continuously.
3 Empty the drip tray and place it back.
ENGLISH 19