Philips HD8824 - WARRANTY AND SERVICE INFORMATION

58 ENGLISH
Machine actions Causes Solutions
The machine grinds the
co ee beans but no co ee is
brewed (see note).
The brew group is dirty. Clean the brew group (see the
"Weekly Cleaning of the Brew
Group" chapter).
The circuit is not primed. Prime the circuit (see the “Using the
Machine for the First Time” chapter).
This might occur when the ma-
chine is automatically adjusting
the dose.
Brew a few cups of co ee as
described in the “Saeco Adapting
System” chapter.
The co ee dispensing spout is
dirty.
Clean the co ee dispensing spout.
The co ee is too weak (see
note).
This might occur when the ma-
chine is automatically adjusting
the dose.
Brew a few cups of co ee as
described in the “Saeco Adapting
System” chapter.
The ceramic co ee grinder is set
to a coarse grind.
Adjust the ceramic co ee grinder
to a  ner setting (see the “Adjust-
ing the Ceramic Co ee Grinder”
section).
Co ee is brewed slowly (see
note).
The co ee grind is too  ne. Change co ee blend or adjust the
grind as explained in the “Adjusting
the Ceramic Co ee Grinder” chapter.
The circuit is not primed. Prime the circuit (see the “Using the
Machine for the First Time” chapter).
The brew group is dirty. Clean the brew group (see the
"Weekly Cleaning of the Brew
Group" chapter).
Co ee leaks out of the co ee
dispensing spout.
The co ee dispensing spout is
clogged.
Clean the co ee dispensing spout
and its holes.
No hot water or steam is
dispensed.
The hole of the steam/hot water
wand is clogged.
Clean the hole of the steam wand
using a pin.
Make sure that the machine is
o and has cooled down before
performing this operation.
The descaling cycle cannot
be  nished.
You have used not enough water
for rinsing.
Press the ON/OFF button and follow
the instructions described in the
“Interruption of the Descaling Cycle”
chapter.
Note:
These problems can be considered normal if the co ee blend has been
changed or if the machine has just been installed. In this case, wait until
the machine performs a self-adjusting operation as described in the "Saeco
Adapting System" chapter.