HD9220/20 /21 /22 /23 /24
7-10
F. Thermostat removal
1. Follow previous step A
2. Remove the 3 screws G from the thermostat assy.
G
G
G
3. Follow previous step B, C, D
By step C do not cut the wires.
Note: be careful with the wire / heating element
connecting, this connection is fragile.
4. Remove the thermostat sensor by undoing the metal band.
metal band
Note: Please make sure while re-assembling the new
thermostat that the routing will be done as
shown in below picture.
DISASSEMBLY- AND RE-ASSEMBLY ADVICE
G. Motor assy removal
1. Follow previous step A, B, C, D
By step C do not cut the wires.
2. Remove the thermostat sensor (See instruction F 4)
3. Remove the fuse and the earth connection from the
double heat shield.
Earth connection
Double
heat shield
Fuse
4. Cut the motor wires half way and remove the motor fan
assy.
To Next Page
Loading...
