Philips HES4900/12 - Get started; Initial Setup and Wireless Connection

18
Set up wireless connection manually
1 In standby mode, press and hold SOURCE
on the main unit for 3 seconds.
» [PAIRING]SDLULQJÁDVKHV
2 Press and hold PAIR on the subwoofer for
3 seconds.
The blue and green indicators on the »
VXEZRRIHUÁDVKDOWHUQDWHO\
If wireless connection succeeds, » [PAIR
OK] (pair OK) is displayed and the
blue indicators on the subwoofer lights
up.
3 Turn on the main unit again.
Note
If the wireless connection fails again, check whether 
WKHUHLVDQ\FRQÁLFWRUVWURQJLQWHUIHUHQFHIRUH[DPSOH
interference from other electronic devices) around
\RXUORFDWLRQ$IWHUUHPRYDORIWKHFRQÁLFWRUVWURQJ
interference, repeat the above procedures.
Find the correct viewing
channel
1
Press DISC to switch to disc mode.
4 Get started
Caution
Use of controls or adjustments or performance of 
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
VHTXHQFH
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
back of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Turn on
1
Press .
The unit switches to the last selected »
source.
2 Wait for automatic setup of wireless
connection between the main unit and
subwoofer.
» [PAIRING]SDLULQJÁDVKHV
If the connection succeeds, » [PAIR OK]
(pair OK) is displayed and the blue
indicator on the subwoofer lights up.
If the connection fails, » [PAIR FAIL]
(pair fail) is displayed and the green
indicator on the subwoofer lights up.
If the wireless connection fails, set up »
the connection manually.
EN