Philips HTS3011 - Page 11

3 - 2 3 - 2
SERVICE POSITIONS
Service position A
Note:In some service positions the components or copper patterns of one board may risk touching its neighbouring pc boards or
metallic parts. To prevent such short-circuit use a piece of hard paper or other insulating material between them.
Dismantling of the Main Board
1) Loosen 4 screws “H” on the top of Main Board as shown in  gure 11.
2) Loosen 6 screws “I” at the back panel as shown in  gure 12.
Figure 10
Dismantling of the DVD Module
1) Loosen 4 screws “ E “ at the DVD Module as shown in  gure 8.
Dismantling of the VFD+JACK+STANDBY Board
1) Loosen 12 screws “F” on the top of VFD+JACK+STANDBY Board as shown in  gure 9.
Figure 8
E
Figure 9
F
Dismantling of the Power Board
1) Loosen 4 screws “G” on the top of Power Board as shown in  gure 10.
G
Figure 11
H
I
Figure 12