Philips HTS3544/37 - System, Region Code, Etc. Setting Produre; Password Change; Upgrading New Software; Version Control Change

2 - 1 2 - 1
System , Region Code , etc. Setting Produre
1)System Reset
a) Press “Setup“ button on R/C,TV will show preference menu
b) Select the menu using the and
on R/C
c) Go preference page to do system reset
2)Region Code Change
a) Press the “stop“ button on R/C in open midel
b)Press “7“ “3“ “4“ “4“ “6“ “6“ on R/C, then input desired number to
change region code :
1 USA
2 EU
3 AP
4 Australia ,NZ , Latam
5 Russia , INDIA
6 CHINA
3)Version Control Change
a) In open model, press “1“ “5“ “9“ on R/C
b) Press “ok” button to con rm
c) TV will show message as below:
7) Upgrading new sofeware
a) Open the CD Door, then insert the CD-R program disc
b) Close the CD Door
c) VFD will show:
“Loading“
“Erase” -- erase the  ash memory
“Writing” about 2 minute
“done “
* the latest upgraded is in version VER 00.25.05_70504_00
Current model HTS3544/37
Version: 00.25.05_70504 Region :1
Servo: 58.58.00.00
8032: 05.00.04.06 RISC: OE.OE.01.00
IF current model does not match you set use down arrow
key on the remote to change
OK
CAUTION!
This information is confi dential and may not be
distributed.Only a qualifi ed service person should
reprogram the Region Code.
4)Password Change
a) Press “Setup “ button on R/C,TV will show preference page
b) Select the menu using the and on R/C
c) Go preference page select “password“ to change
* 000000 is default password supplied.
5)Check on the Sofeware Version
a) Open the CD Door
b) Press “display“ button on R/C
c) TV will show the version on screen
6)Trade model
a) Press “Open/Close “ button on R/C
b) Press “2” “5” “9” on R/C,VFD will display “TRA ON “ or “TRA
OFF“