Philips HU2510 - Getting started; Prepare for humidification; Using the humidifier; Switching the humidifier on and off

6 EN
3 Getting started
Prepareforhumidication
Note:
•
In order to get the optimal humidication result, soak the lter in water for
30minutes before use.
54 61 2 3
1 Hold by both sides of the upper unit and lift it up.
2 Remove the packaging material of the new humidication lter.
3 Assemble the new humidication lter around the lter support.
4 Put the humidication lter and the lter support back into the water tank.
5 Fill the water tank with cold tap water until water reaches the maximum water
level indication.
6 Place the upper unit back onto the water tank.
4 Using the humidifier
Switchingthehumidieronando
1 Put the plug of the humidier into the power socket.
2 Press or switch on the humidier�
•
: Gentle mode
•
: Turbo mode
3 Press the power button to switch o the humidier.
Note:
•
If the water level in the tank is getting very low, the
humidier stops humidifying. The indicator light is on.
•
The humidier releases very ne invisible mist, so it is normal that you cannot
see the mist.