Philips HU2510 - Water level; Refilling water

7EN
Water level
When there is not enough water in the water tank, the indicator is on, the
humidier stops working, The humidier will resume work when you rell water
into the water tank.
Note:
•
It is normal to nd some water left in the tank.
Rellingwater
Note:
•
When lling water, do not exceed the maximum water level, or water might leak
from the air inlets.
•
Do not shake the water tank when moving it, or water might leak from the air
inlets.
•
Do not ll water through the air outlets on top of the humidier.
1 Switch o the humidier and unplug it.
2 3
4
2 Remove the upper unit by holding it at both sides.
3 Fill the water tank with cold tap water until water reaches the maximum water
indication level.
4 Place the upper unit back onto the water tank.