EasyManua.ls Logo

Philips HU4810 - Cleaning the Humidification Filter; Replacing the Humidification Filter

Philips HU4810
122 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
EN
6 Cleaning the
humidification
filter
Clean the humidication lter every
week to keep it hygienic.
1 Switch o the humidier and unplug
it (g j).
2 Hold by both sides of the upper unit
and lift it up (g b).
3 Take out the humidication lter
and the lter support from the water
tank (g k).
4 Remove the humidication lter
from the lter support (g l).
5 Soak the humidication lter in tap
water for one hour (g m).
6 Rinse the humidication lter under
a slowly running tap (g n).
7 Let excess water drip o the
humidication lter.
8 Assemble the humidication lter
round the lter support (g d).
9 Put the humidication lter and the
lter support back into the water
tank (g e).
10 Place the upper unit back onto the
water tank (g g).
Note
Do not squeeze or wring the lter. This
might damage the lter and impact
humidication performance.
Do not dry the lter under direct
sunlight, unless it is assembled back
onto the lter support
7 Replacing the
humidification
filter
Replace the humidication lter every
three months for optimal performance.
If the lter is in good condition, you
could use it for a longer period of time.
Make sure to replace the humidication
lter at least once a year.
Note
Use only Philips original humidication
lter HU4102.
Tip
Register your product at www.philips.com
for further information on how to replace
your lter.
1 Switch o the humidier and unplug
it (g j).
2 Hold by both sides of the upper unit
and lift it up (g b).
3 Take out the humidication lter
and the lter support from the water
tank (g k).
4 Remove the humidication lter
from the lter support. Discard the
used lter (g o).
5 Remove the packaging material of
the new humidication lter (g c).
6 Assemble the new humidication lter
around the lter support (g d).
7 Put the lter and the lter support
back into the water tank (g e).
8 Place the upper unit back onto the
water tank (g g).
Tip
You can easily nd more information
about how to replace the lter in our
web page or by calling our Consumer
Care Center.

Table of Contents