Philips HU4810 - Using the Humidifier; Switching On and Off; Water Level Monitoring; Refilling the Water Tank

6
EN
4 Using the
humidifier
Switch the humidier on
and o
1 Put the plug in the wall socket.
2 Turn the control knob to low
speed or high speed (g h).
» The speed light and the
humidier are on (g i).
3 Turn the control knob to OFF.
» The speed light is o.
» The humidier is o.
Note
• The humidier releases very ne invisible
mist, so it is normal that you cannot see
the mist.
Water level
When there is not enough water in the
water tank, the speed light will be o
and the humidier stops working. The
control knob stays at the chosen speed.
When you rell water, the humidier will
resume work at the chosen speed.
Note
• It is normal to nd some water left in the
tank.
Rell water
Water level can be observed through
the transparent water tank window.
1 Switch o the humidier and unplug
it (g j).
2 Hold by both sides of the upper unit
and lift it up (g b).
3 You can observe the water level
through the transparent water tank
window. Fill the water tank with cold
tap water until the water reaches
the maximum water indication level
(g f).
Note
• When lling water, do not exceed the
maximum water level, or water might leak
from the drain hole and air inlets.
• Do not shake the water tank when
moving it, or water might leak from the
drain hole and air inlets.
• Do not ll water through the air outlets
on top of the humidier.
4 Place the upper unit back onto the
water tank (g g).