Philips In Ear UT102 - Factory Reset and Wearing; Factory Reset Procedure; How to Wear Earpieces

5 Factory reset
the earpieces
How to wear
Low battery level
(earpieces).
Low battery level
(charging case).
Only the first blue
LED goes on
You will hear
‘battery low’ on
the earpieces.
The white LED
flash twice.
Battery LED indicator on
earpieces status
Battery is fully
charged(earpieces)
The white LED on
the earpieces is off
Battery is fully
charged(charging
case).
The four blue LED
on the charging
case is on.
It will show a battery indicator on
Bluetooth device after connected to
earpieces.
If you encounter any pairing or connection
issue, you can follow the following
procedure to factory reset your earpieces.
On your Bluetooth device, go to the
Bluetooth menu and remove
Philips UT102 from the device list.
Put both earpieces back to charging
case. Both earpieces flashes white led.
Press and hold both earpieces
function button for 4s,until earpieces
flashes twice white led .
To pair the earpieces with a Bluetooth
device, turn on the Bluetooth function
of your Bluetooth device, select
Philips UT102.
Turn off the Bluetooth function of your
Bluetooth device.