Philips In Ear UT102 - Pair the Earpieces with Your

Both earpieces are now
powered on and are paired
with each other.
The earpieces is now in pairing
mode and is ready to pair with a
Bluetooth device (e.g. a mobile
phone).
Turn on the Bluetooth function of
your Bluetooth device.
Note
 After powering on, if the earpieces cannot find
any previously connected Bluetooth device, it
will automatically switch to pairing mode.
In right earpieces, it has voice
“Connected”and LED goes off on
both earpieces and flash 1 time
every 10s. You can use your device
to play music or make a call.
Pair the earpieces with your
Bluetooth device. Refer to the user
manual of your Bluetooth device.
Philips UT102
Turn on the Bluetooth function
of your Bluetooth device, select
Philips UT102.
Enter the earpieces password
“0000” (4 zeros) if prompted.
For those Bluetooth devices
featuring Bluetooth 3.0 or higher,
no need to enter a password.
The following example shows you
how to pair the earpieces with
your Bluetooth device.
Pair the earpieces with
your Bluetooth device at
the fist time
Make sure that the earpieces is fully
charged.
Auto power on: open the charging
capsule, the earpieces discharged
and the blue LED indicator flash for 3
times with “power on” voice prompt;
Manual power on: on both earpieces
press and hold the multi-function
buttons for approxinmately 3s.
The right earphone led flashes
alternately in white and blue, and
the left earphone LED is off for 10s
and the blue LED flashes once.
Blue LED
flashes once
for 10s
LED flashes
alternately in
white and blue