Philips Lumea SC2009 - Device Positioning and Flash Release; Treatment Modes: Stamp & Flash and Slide & Flash

3 Press the device rmly onto your skin to ensure proper skin contact.
The 'ready to ash' light on the back of the device lights up green to indicate
that you can proceed with the treatment.
4 Press the ash button to release a ash. You should feel a warm
sensation because of the ash.
Note: The light produced by the device is harmless to your eyes. It is
not necessary to wear goggles during use. Use the device in a well-lit
room so that the light is less glaring to your eyes.
5 Place the device on the next area to be treated. After each ash, it takes
up to 3.5 seconds until the device is ready to ash again. You can release
a ash when the 'ready to ash' light lights up again.
6 To make sure that you have treated all areas, release the ashes close
to each other. However, make sure you ash the same area only once.
Flashing the same area twice doesn't improve the eectiveness of the
treatment, but increases the risk of skin reactions.
Two treatment modes: Stamp & Flash and Slide & Flash
Your Philips Lumea has two treatment modes for more convenient use on
dierent body areas:
- The Stamp & Flash mode is ideal to treat small or curvy areas like knees
and underarms. Simply press and release the ash button to release a
single ash.
- The Slide & Flash mode oers convenient use on larger areas like legs.
Keep the ash button pressed while you slide the device over your
skin to release several ashes in a row.
19
English