39
3139 115 22871
English
Cannot activate some features such as
Angles, Subtitles, or multi-language
Audio.
No able to select some Items in the
setup/system menu.
There is no sound from the centre and
surround speakers.
Radio reception is poor.
The remote control does not function
properly.
Low hum or buzz sound.
Unable to play DivX movies.
The DVD system does not work.
– The features may not be available on the DVD.
– Changing the language for the sound or
subtitle is prohibited on the DVD.
–Press STOP button twice before selecting the
setup/system menu.
–Depending on the disc availability, some menu
items cannot be selected.
– Make sure the centre and surround speakers
are connected correctly.
–Press SURR button to select a correct
surround sound setting.
– Make sure the source you are playing is
recorded or broadcast in surround sound
(DTS, Dolby Digital, etc.).
– The wireless transmitter and receiver must
using the same transmission frequency.
– If the signal is too weak, adjust the antenna or
connect an external antenna for better
reception.
– Increase the distance between the system and
your TV or VCR.
–Tune in to the correct frequency.
–Place the antenna farther away from any
equipment that may be causing the noise.
– Select the source (DISC or TUNER, for
example) before pressing the function button
(ÉÅ, S ,
T).
– Reduce the distance between the remote
control and the system.
– Replace the batteries with new ones.
–Point the remote control directly toward the
IR sensor.
– Check that the batteries are loaded correctly.
– Place the DVD system as far away as possible
from electrical devices that may be causing
interference.
– Check that the DivX file is encoded in ‘Home
Theatre’ mode with DivX 5.x encoder.
– Disconnect the power cord from the power
outlet for a few minutes. Reconnect the power
cord and try to operate again as usual.
Problem
Solution
Troubleshooting
001-041-LX39-22-Eng1 12/12/2003, 10:21 AM39
To Next Page
Loading...
Need help?
General
