English
IMPORTANT!
Make sure the FM and MW
antennas are connected.
Tuning to radio stations
1 Press TUNER on the remote (or press
SOURCE control on front panel) to
select “FM” or “MW”.
2 Press 34 briefly on the remote.
➜ "SEARCH" appears.
➜ The next radio station will tune
automatically.
3 To tune a weak station, press S / T
briefly and repeatedly until an optimal
reception is found.
Presetting radio stations
You can store up to 20 FM and 10 MW
preset radio stations in the memory.
Helpful Hints:
– The system will exit presetting mode if no
button is pressed within 20 seconds.
– If no valid frequency is detected during
Plug and Play,"CHECK ANTENNA" appears.
Using the Plug and Play
Plug and Play allows you to store all
available radio stations automatically.
AUTO INSTALL PRESS PLAY
1
2
1 For first time setup, press SOURCE
on front panel to select TUNER mode.
➜ "AUTO INSTALL PRESS PLAY"
appears.
Tuner Operations
2 Press 2; on the front panel to start
installation.
➜ "INSTALL TUNER" appears.
➜ Once completed, sı] last tuned radio
station will play.
➜ FM followed by MW bands will be
stored.
Automatic presetting
You can start the automatic presetting
from a selected preset number.
1 Press TUNER on the remote to select
“FM” or “MW”.
2 Press 1 2 or use the numeric keypad
(0-9) to select a preset number to begin.
3 Press and hold PROG until "AUTO"
appears.
➜ If a radio station is stored in one of the
earlier presets, the same radio station will
not store under another preset number.
➜ If no preset number is selected,
automatic preset will begin from preset
(1) and all your former presets will be
overridden.
DVD system’s
display panel
001-039-LX39-93-EngFinal 08/04/2004, 01:48 PM32
To Next Page
Loading...
