Preparations
C Speakers Connection
Front Speakers
Connect the speaker wires to the SPEAKERS
terminals, right speaker to "RIGHT" and left
speaker to "LEFT", coloured (marked) wire to
"+" and black (unmarked) wire to "-".
1
2
● Fully inser t the stripped portion of the speaker
wire into the terminal as shown.
Notes:
– For optimal sound performance, use the
supplied speakers .
– Do not connect more than one speaker to any
one pair of
+
/
-
speaker terminals.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
D Connecting a TV
Co
nnect the
VI
DEO OUT
t
erminal at the rear
of the system to the TV or VCR VIDEO IN for
viewing or recording.
Note:
– To avoid magnetic interference, do not position
the fr ont speak
ers too close to your TV.
E Connecting other equipment to your
system
Use a cinch cable to connect AUX IN to the
analogue audio out terminals of an external
equipment (TV, VCR, Laser Disc player, DVD
player or CD Recorder).
Note:
– If you are connecting to equipment with only
mono output (a single audio out ter
minal), connect
it to the AUX IN left terminal. Alternatively, you can
use a “single to double” cinch cable, but the output
sounds still remain mono.
Inserting batteries into the
remote control
Insert two batteries type R03 or AAA (not
supplied) into the remote control with the
correct polarity as indicated by the "+" and
"-" symbols inside the battery compartment.
CAUTION!
– Remove batteries if they are exhausted
or will not be used for a long time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances , so
they should be disposed off properly .
To Next Page
Loading...
