English
xxxxx
11
Basic Functions
IMPORTANT:
Before you operate the system, complete
the preparation procedures.
Switching the system on
● Press POWER (y on the remote control) or
SOURCE.
➜ The system will switch to the last selected
source.
● Press SOURCE (CD, TUNER or TAPE on
the remote control).
➜ The system will switch to the selected source.
To switch the system to standby mode
● Press POWER (y on the remote control).
● If in tape mode or recording mode, press
STOP•OPEN first.
➜ The volume level (up to maximum volume
level of 20), interactive sound settings, last
selected source and tuner presets will be
retained in the player's memory.
Power-saving automatic standby
The power-saving feature automatically switches
to standby 15 minutes after a tape or CD
playback has ended and no control is operated.
Adjusting volume and sound
1
Press VOLUME G / H (3 / 4 on remote
control) to increase or decrease volume.
➜ Display shows the volume level UoL and a
number from 0-32.
2 Press DBB to switch bass
enhancement on or off.
➜ Display shows: DBB
if
the DBB is activated.
3 Press MUTE on the
remote control to stop
sound play-back instantly.
➜ Playback will continue
without sound and the
display shows MUTE .
● To start sound playback you can:
– press MUTE again;
– adjust the volume controls;
– change source.
pg001-021_MC145_55_Eng 21/12/05, 9:3411
To Next Page
Loading...
