English
xxxxx
11
Basic Functions
IMPORTANT:
Before you operate the system, complete
the preparation procedures.
Switching the system on
● Press STANDBY-ON (y on the remote
control) or SOURCE.
➜ The system will switch to the last selected
source.
● Press SOURCE (CD, TUNER or TAPE on
the remote control).
➜ The system will switch to the selected source.
To switch the system to standby mode
● Press STANDBY-ON (y on the remote
control).
● If in tape mode or recording mode, press
STOP•OPEN first.
➜ The volume level (up to maximum volume
level of 20), interactive sound settings, last
selected source and tuner presets will be
retained in the player's memory.
Power-saving automatic standby
The power-saving feature automatically switches
to standby 15 minutes after a tape or CD
playback has ended and no control is operated.
Adjusting volume and sound
1
Press VOLUME 3 / 4 (VOL 3 / 4 on the
remote control) to increase or decrease volume.
➜ Display shows the volume level Uo and a
number from 0-32.
2 Press DBB 1 or DBB 2 (DBB on the remote
control) to switch bass enhancement on or off.
➜ Display shows:
or
if the DBB is
activated.
3 Press MUTE on the remote
control to stop sound play-
back instantly.
➜ Playback will continue
without sound and the display
shows .
● To start sound playback you can:
– press MUTE again;
– adjust the volume controls;
– change source.
To Next Page
Loading...
Need help?
Sound
Loudspeakers
