The remote control does not function – Select the source (CD or TUNER, for example)
properly. before pressing the function button (É,í,ë).
– Reduce the distance betw een the remote control
and the system .
–Inser t the batter ies with their polar ities
(+/– signs) aligned as indicated.
– Replace the batter ies.
–Point the remote control directl y toward
IR sensor on the front of the system .
The timer is not working. – Set the clock cor rectl y.
– Press TIMER ON•OFF to switch on the time r.
– If a recording is in progress, stop the recording.
The Clock/Timer setting is erased. –P
ow er has been inter r upted or the pow er cord
has been disconnected. Reset the clock/time r.
Troubleshooting
INSTRUCTIONS FOR USE
For more information onoperation instruction please visit Philips
Audio internet site :
http://www.audio.philips.com
Troubleshooting
WARNING
Under no circumstances should you try to repair the system yourself, as this will invalidate the
warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If you
are unable to remedy a problem by following these hints, consult your dealer or service centre.
Problem Solution
CD OPERATION
“NO DISC” is displayed. –Insert a disc .
– Check if the disc is inser ted upside down.
–W
has cleared.
– Replace or clean the disc , see “Maintenance”.
– Use a finalised CD-RW or CD-R.
RADIO RECEPTION
Radio reception is poor. – If the signal is too weak, adjust the antenna or
connect an external antenna for better reception.
–Increase the distance betw een the Micro HiFi
System and your TV or VCR.
TAPE OPERATION / RECORDING
Recording or playback cannot be made. –Clean deck parts, see “Maintenance”.
– Use only normal (IEC I) tape for recording.
– Appl y a piece of adhesive tape ov er the missing
tab space.
GENERAL
The system does not react when buttons – Rem ove and reconnect the AC power plug and
are pressed. switch on the system again.
Sound cannot be heard or is of poor – Adjust the volume .
quality. –Disconnect the headphones.
– Check that the speaker s are connected correctl y.
– Check if the str
ipped speaker wire is clamped.
The left and right sound outputs are – Check the speaker connections and location.
reversed.
To Next Page
Loading...
