EasyManua.ls Logo

Philips MCD388 - C001 SWF_RX-Receive Board - Circuit Diagram - Part1

Philips MCD388
35 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
29
Select automatic loudness control
Automatic loudness control increases the treble
and bass effect at low volume levels (the higher
the volume, the lower the treble and bass
levels).
1 To turn on automatic loudness control,
press LOUD/DBB during play until the
loudness icon is displayed.
To turn off automatic loudness
control, press LOUD/DBB until the
loudness icon disappears.
Select surround sound effect
DVS (Dolby Virtual Speaker) technology
creates a highly compelling 5.1-channel listening
experience from as few as two speakers. It is an
ideal entertainment solution for locations where
space for multiple speaker setup is limited.
1 During play, press SURROUND to turn
on/off surround sound effect.
Mute sound
1
During play, press MUTE to mute/unmute
sound.
Listen through headphone
1
Plug a headphone into the socket on
the unit.
8 Adjust volume
level and sound
effect
Adjust volume level
1
During play, press VOL +/- to increase/
decrease the volume level.
Adjust subwoofer volume
1 Press SUBW VOL to adjust the subwoofer
volume.
Select a sound effect
Note
You cannot use different sound effects at the same
time.
Select a preset sound effect
1 During play, press DSC repeatedly to
select:
[ROCK] (rock)
[JAZZ] (jazz)
[POP] (pop)
[CLASSIC] (classic)
[FLAT] (fl at)
Enhance bass
1 To turn on bass enhancement, press
LOUD/DBB repeatedly during play until
the DBB logo is displayed.
To turn off bass enhancement,
press repeatedly until the DBB logo
disappears.
English
EN

Table of Contents

Other manuals for Philips MCD388

Related product manuals