42
English
The remote control does not function.
The display is dark.
Low hum or buzz sound.
Low bass response.
Unable to select Progressive Scan.
No sound is output from the HDMI jack.
No sound and picture
✔ Select the correct source (DISC or TUNER, for
example) before pressing the function button.
✔ Point the remote control at the remote sensor
of the unit.
✔ Reduce the distance to the player.
✔ Remove any possible obstacles.
✔ Replace the batteries with new ones.
✔ Check that the batteries are loaded correctly.
✔ Press DIM again.
✔ Place the DVD micro system as far away as
possible from electrical devices that may be
causing interference.
✔ Check all speakers for correct polarity.
✔ Check that the output of the video signal is
switched to 'Pr/Cr Pb/Cb Y'.
✔ Check the connection between the TV and the
HDMI jack of the DVD player.
✔ See if the TV supports this 480p/576p/720p/
1080i DVD player.
✔ Check your TV system setup correctly.
✔ Check that the RGB/SCART cable is connected
to the correct device (See Connecting TV).
Tr oubleshooting
To Next Page
Loading...
