16
English
Radio Reception
Tuning to radio stations
1 Select TUNER source.
2 Press SOURCE on the set repeatedly or press
TUNER on the remote repeatedly until the
desired waveband (FM or MW) is displayed.
3 Press down on TUNING 4 ¢ and release
button.
➜ The radio automatically tunes to a station
with sufficient reception. Display indication during
automatic tuning: SEARCH.
4 Repeat step 3 if necessary until you find the
desired station.
● To tune to a weak station, press TUNING 4
¢ briefly and repeatedly until you have found
optimal reception.
Programming radio stations
You can store up to a total of 40 radio stations
in the memory.
Automatic programming
Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden. The system will only programme
stations which are not in the memory already.
1 Press ALBUM/PRESET 4 3 to select the
preset number where programming should start.
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
2 Press PROG for more than 2 seconds to
activate programming.
➜ AUTO is displayed and available stations are
programmed in order of waveband reception
strength. The first preset automatically stored will
then be played.
Manual programming
1 Tune to your desired station (see Tuning to radio
stations).
2 Press PROG to activate programming.
➜ PROG flashes in the display.
3 Press ALBUM/PRESET 4 3 to allocate a
number from 1 to 20 to this station.
4 Press PROG again to confirm the setting.
➜ PROG disappears, the preset number and the
frequency of the preset station are shown.
5 Repeat the above four steps to store other
stations.
● You can override a preset station by storing
another frequency in its place.
Tuning to preset radio stations
● Press ALBUM/PRESET 4 3 until the desired
preset station is displayed.
PG 001-024_MCM204_12-Eng 6/17/08, 11:2616
To Next Page
Loading...
