24
English
The remote control does not function
properly.
The time is not working.
The Clock/Timer setting is erased.
The USB device doesn’t play on my
MCM204
✔ Select the source (CD or TUNER, for example)
before pressing the function button (É,í,ë).
✔ Reduce the distance between the remote
control and the system.
✔ Insert the batteries with their polarities
(+/– signs) aligned as indicated.
✔ Replace the batteries.
✔ Point the remote control directly towards the IR
sensor.
✔ Set the clock correctly.
✔ Press TIMER to switch on the timer.
✔ If recording or tape dubbing is in progress, stop
recording.
✔ Power has been interrupted or the power cord
has been disconnected. Reset the clock/timer.
✔ It is not set in the USB mode. Select USB mode.
✔ The device is not securely connected to
MCM204’s USB port. Re-connect the device, and
make sure that the device is powered on.
✔ The device is not supported by MCM204, or the
audio file format stored on the device is not
supported by MCM204. Use a compatible
device/ playable audio file format.
Troubleshooting
Problem
Solution
PG 001-024_MCM204_12-Eng 6/17/08, 11:2624
To Next Page
Loading...
