English
21
Tuner
Tuning to radio stations
1 Press SOURCE once or more to select
TUNER (or TUNER on the remote control)
2 Press TUNER on the remote control
repeatedly to select your desired waveband, FM
or MW
➜ Display shows: , radio station frequency,
waveband and if programmed, a preset number
3 Press and hold 4 / ¢ until SEARCH
appears
➜ The radio automatically tunes to a station
with sufficient reception. Display shows SEARCH
during automatic tuning
➜ FM: If a station is received in stereo, is
shown
➜ FM: When you are receiving an RDS station,
is shown
4 Repeat step 3 if necessary until you find the
desired station.
● To tune to a weak station, press 4 / ¢
briefly and repeatedly until you have found
optimal reception.
Programming radio stations
You can store up to a total of 40 radio stations
(FM and MW) in the memory, manually or
automatically (Autostore).
Autostore: Automatic programming
Automatic programming will start from preset 1
or a chosen preset number. From this preset
number upwards, former programmed tuner
stations will be erased. The set will only program
stations which are not in the memory already.
1 Press the 3 / 4 buttons once or more to select
the preset number where programming should
start.
Note:
– If no tuner preset number is selected, default is
preset 1 and all your presets will be erased.
2 Press and hold PROG until AUTO appears
➜ flashes
➜ Available stations are programmed: RDS
stations followed by FM stations, MW stations
(See RDS)
➜ After all stations are stored, the last preset
station will then be played
Manual programming
1 Tune to your desired station (see Tuning to
radio stations)
2 Press PROG to activate programming
➜ flashes
3 Press 3 / 4 to allocate a number from 1 to 40
to this station.
4 Press PROG to confirm
➜ Display shows the preset number, waveband
and the frequency of the preset station
5 Repeat steps 1-4 to store other stations
● You can erase a preset station by
storing another frequency in its place
To listen to a preset station
● Press the 3 / 4 buttons once or more until the
desired preset station is displayed.
P001-P029_MCM277_22_Eng 2007.12.27, 16:3221
To Next Page
Loading...
