11
English
Basic Functions
IMPORTANT!
Before you operate the system, complete
the preparation procedures.
Switching the system on
● Press STANDBY ON 2 or SOURCE.
➜ The system will switch to the last selected
source.
● Press CD, TUNER, TAPE or AUX on the
remote control.
➜ The system will switch to the selected source.
Switching the system to Eco
Power Standby mode
● Press STANDBY-ON / 2 in the active mode.
➜ The backlight of clock display is dim in
standby.
● The volume level, interactive sound settings, last
selected mode, source and tuner presets will be
retained in the player's memory.
● To view the clock time in Standby mode, press
and hold STANDBY-ON / 2 for 3 seconds
or more.
➜ The system enters the normal standby mode
with clock display.
● Press and hold STANDBY-ON / 2 for 3
seconds or more to go back to Eco Power
Standby mode.
Power-saving automatic standby
As a power-saving feature, the system will
automatically switch to Standby mode if you do
not press any buttons within 15 minutes after a
disc or tape has stopped playing.
Volume control
Adjust VOLUME (VOL + / -) to increase or
decrease the volume level.
➜ Display shows the volume level "VOL" and a
number from 1-31. “MIN” denotes the minimum
volume level and “MAX” denotes the maximum
volume level.
To switch off the volume temporarily
● Press MUTE on the remote control.
➜ Playback will continue without sound and
"MUTE" is displayed.
● To restore the volume, press MUTE again or
increase/decrease the volume level.
Sound control
● Press DSC repeatedly to select the desired
sound effect : OPTIMAL, ROCK, JAZZ or POP.
● Press INCREDIBLE SURROUNDS/DBB to
switch on or off the surround sound effect or
bass enhancement.
➜ The sequences are as follows :
DBB ™ INCR.SURR. ™ DBB+INCR.SURR.
➜ If the DBB is activated, DBB is shown.
➜ If the IS is activated, is shown.
Note:
– The effect of INCREDIBLE SURROUND may
vary with different types of music.
DISPLAY/BAND
pg 001-021_M390_21-Eng 2/2/05, 14:2811
To Next Page
Loading...
